I jus got the NEW! 0-mile SCAT 2180 it looks Bad-As* They even sent it in a cage must be an animal ! (Very Happy)

Also got the NEW! Trans from DON's BUS BOX all Weddle racing internals DON has really out done himself this time! (Very Happy)

Trick 5x5 Duel pivot rear trailing arms.

Tatum 2 piston front and 4 piston rear disk brakes and hubs.

930 race prep CV's

10 inch over beam

Fodrail front arms and combo spindles

PCI race radio's W/intercom and carbon fiber headsets

Go-Pro HD HERO in car cameras

and dropped the chasses to the powder coater to get coated while we paint the body we are getting close!!!!

That was a crazzy DAY!

PS
got the new plate for the car AZ. ( VW2BAJA )

Drove mine for first time

took a old cv with no boot but good bearings slapped in and made a boot out of plastic wrap duct tape and electrical tape
cant wait for tomorow it is going to be so much fun

Got all my parts painted to reassemble the engine

Degrease the engine to find out where the leak is coming from, its getting bad. It appears to be coming from the bolt between the cylinders on the right side, but it is hard to tell. Now to figure out the fix. Oh and drove the kids around some for some good fun, love it.

attacked it with a roller for the 60.00 paint job haha.

Brib wrote:

Degrease the engine to find out where the leak is coming from, its getting bad. It appears to be coming from the bolt between the cylinders on the right side, but it is hard to tell. Now to figure out the fix. Oh and drove the kids around some for some good fun, love it.

I've got the same leak even after a quick turn of the wrench. Hmmmm?

Fired mine up today in the garage with turbo installed, probably irritated the neighbors and thought about how I can skip summer here in AZ and go right to winter for some more Dune trips HA HA.

Got the block assembled

Shady, I love the bloody hand print.. Kinda looks like some thing I've done after bloodying my hands working on the baja.

Crest, I love that paint scheme on your engine! That is cool!!

I feel bad I havent touched any of my bajas in a few weeks, had to run to Vegas to visit my sis in law after she rolled her suv twice(she is ok just destroyed the car) and then spent the last week putting a motor in the wifes cavalier after it got a rod knock. OK I've done enough wineing I'm going out to the garage cleaning it up and working on a BAJA!

Have to have the New Mexico State Police mosey by and check my VIN's...just want to keep it all safe and legal.

Then I'll get the link-pin head welded on, followed by powdercoating...the passenger side gets bedliner, and the road side undercoating after that.

I can't WAIT to blend a '68, a '71, and a '73 into a Baja!

One step at a time...but always forward...

Dave C.

Got my conversion beam today

Now its time to blast all the parts for powdercoat. Feels like its been months since i have made progress on anything.. oh wait. It has.

Finally got my backup transaxle in the rail. Last month the other one gave up in Ironwood Wash on a moonless night. Fortunately I was on a recovery with Joe and we were able to get it out the same night.

Late post, this was my weekend of work




Runs alot better now