help

Post subject: help Posted: Sun Jul 27, 2008 07:07 AM

im finally gettin around to putting my front end back together after installing adjusters...
i need some advice or tips on getting the springs through the adjusters...i can get all the spring through except the two middle springs (thickest ones) they seem to be catching somewhere

ive tried taping em, and got the same problem

thanks

Post subject: Re: help Posted: Sun Jul 27, 2008 05:59 PM

did you back the little set screw out

Post subject: Re: help Posted: Sun Jul 27, 2008 08:06 PM

yes, there is nothin blocking it, just getting hung up at the adjusters

Post subject: Re: help Posted: Mon Jul 28, 2008 06:39 AM

im about to stick mine in tomorrow, i got the 4 big ones in 5 or six times today, when mocking up my adjusters. im sure it gets a little tricky with all the small springs though.

Post subject: Re: help Posted: Mon Jul 28, 2008 07:01 AM

It's been a while for me. I remember lots and lots of grease being involved, though.

Post subject: Re: help Posted: Mon Jul 28, 2008 08:49 PM

ok i finally got em all in, the big springs were tricky! , but with a little time off wiggling, pushing, and yelling i got em in

Post subject: Re: help Posted: Tue Jul 29, 2008 12:17 AM

i was just gonna say, i stuck mine in about 5 min ago. stuck a zip tie about an inch from the end and they slid right in.

Post subject: Re: help Posted: Tue Jul 29, 2008 06:42 AM

cperry2704 wrote:

ok i finally got em all in, the big springs were tricky! , but with a little time off wiggling, pushing, and yelling i got em in

Yelling always seems to help quite a bit doesn't it? Cool

well it helps me out most of the time anyway... Rolling Eyes